Automatic Lid Applicator

General Discription

 

The lids are manually load to the the magazine on correct position. The capacity of the magazine is about 150 lids.

The lids are ejected by a pneumatic piston on a certain time. The ejected lids goes to labelling unit if the labels needed. Now a days the lid are produced with label. This technology call inmould. So you the producers of wet wipes do not have invest in label seperatly and use down time from labelling unit

 

Lid magazine

The lids are manually load to the the magazine on correct position. The capacity of the magazine is about 150 lids.

The lids are ejected by a pneumatic piston on a certain time. The ejected lids goes to labelling unit if the labels needed. Now a days the lid are produced with label. This technology call inmould. So you the producres of wet wipes do not have invest in label seperatly and use down time from labelling unit.

 

Labelling Unit

Labelling unit is an option for for the reasons mentione above. In any case a labeling unit can be installed on later stages if needed.

 

Vaccum pads

The vaccum pads pick the lids when arrived to correct position. This position is determind by a sensor. Also a sensore connected to the vacuum pads to make sure there is a lid picked up. Also thad sensor send signals to the hotmelt unit to sprey glue to the lid. That system makes sure if there no lids then no glue spreyed so the glue is not wates and there is mass around.

 

Products Supply

The products are supplied from flow pack machine. The lid applicator machine conneted to exit of the flow pack machine. No manual transfer need.

The products on the conveyor is dedected by a camera to locate the product location. The camera  is identify the symbol that you have teached. The camera ıdentifys the products and the send signal to vacuum pads when and where to stick the glued lisds. If there is no products the lids are not dropped on the conveyor. If the products delayed after so much time then the lids dispossed to indetied safe place in order not to make mass around.

 

Application of Glue

The glue is applied to the bottom of the lid. There are x and y axis to be glued. Area of x and y axises are determind from the touch screen. That enable us to glue any size of lids. It is nly matter of putting right coordinates.

 

Setting of Glue

The amount of glued is can be set up from the air pressure of hot melt unit. Also the type of nozzle is also importand. According to area the type of nozzle is determind.

 

.

Product Dimenssion

Thge product dimentions are are not standart. Bellow mentioned dimenssions can be used

Length            : 150mm-270mm

Width             : 90mm-180mm

Height             : 30-150

 

Lids Dimesion

Lenght            : 50mm-150mm

Width             : 50mm-80mm

Height            : 5mm-10mm

 

Capacity

50 lids/min

 

Machine Dimmension

Width             : 1200mm

Lenght            : 3750mm

Height            : 1850mm

 

Penaumatic Componenets

Festo / Airworks

 

Servo Motors / Drives

Allen Bradley / Siemens / Omron

 

Hotmelt Glue Unit

Dynatec / Nordson / Robatech

(as per customer request. The standart is Dynatecmini) price diference will be optional)

 

Air

6 Bar

 

Power

380 VAC, 50 hz.